From pots of gold to shamrock cookie cutters, we've got a definitive list of easy-to-print accessories to help you celebrate St Paddy's Day! Get to it.

15 Festive 3D Prints to Celebrate Saint Patrick's Day | All3DP

Plants Pots

Stackable Planter

This is a 4 tier hydroponic system, it is still a work in progress. Use small pots or directly in the system itself. It was built to fit the Ultimaker 2 platform as per the dimensions they state, but after I noticed it needed to be printed at 98% to properly print. Normal to high quality print only. Need to ensure it is water tight for siphon to work properly. A 5 gallon bucket design is also included, made to fit a 11,75in ID standard bucket. I designed a clear or natural print cover to fit. But at this point it is not necessary.&#xA0; I printed a very small scale version to test the siphon system; it functioned. When the container became near full the drain began to drain until it was near empty again. Some will adjustments to the bell siphon exit port or to the pump will need to be made. This is to properly match the flow output vs input. The output should always be higher than the input. This way the water will never overflow and only fully drain then fill again. Scaled down test can be seen here: <iframe width="593" height="370" src="//www.youtube.com/embed/TiNvjXs6TaQ" frameborder="0" allowfullscreen></iframe>

Desktop Hydroponics

This is a 4 tier hydroponic system, it is still a work in progress. Use small pots or directly in the system itself. It was built to fit the Ultimaker 2 platform as per the dimensions they state, but after I noticed it needed to be printed at 98% to properly print. Normal to high quality print only. Need to ensure it is water tight for siphon to work properly. A 5 gallon bucket design is also included, made to fit a 11,75in ID standard bucket.I designed a clear or natural print cover to fit. But at this point it is not necessary. I printed a very small scale version to test the siphon system; it functioned. When the container became near full the drain began to drain until it was near empty again. Some will adjustments to the bell siphon exit port or to the pump will need to be made. This is to properly match the flow output vs input. The output should always be higher than the input. This way the water will never overflow and only fully drain then fill again. Scaled down test can be seen here:


Desktop stackable planter. For small plants and herbs. Place tubing and pump in tank for continuous cascade watering system Print 4 pins / planter. Print and stack as needed. Use Solid tube/plug for bottom planter, or use a plate to catch water.

Stackable Cascade Planter Ver2

Desktop stackable planter. For small plants and herbs. Place tubing and pump in tank for continuous cascade watering system Print 4 pins / planter.Print and stack as needed.Use Solid tube/plug for bottom planter, or use a plate to catch water.


12 Pencil Pot, double function design. The holder combined with pencils will become a bigger pot, which can contain other items inside. 

Recommended settings for FDM/FFF 3d printers:

Layer height: 0.1 - 0.3 mm (thinner layers, finer details but slower printing time)

Infill: 100 %

Speed: 50 mm/s

12 Pencil Pot

12 Pencil Pot, double function design. The holder combined with pencils will become a bigger pot, which can contain other items inside. 

Recommended settings for FDM/FFF 3d printers:

Layer height: 0.1 - 0.3 mm (thinner layers, finer details but slower printing time)

Infill: 100 %

Speed: 50 mm/s


Thingscanner

Some articles you might like

15 Festive 3D Prints to Celebrate Saint Patrick's Day | All3DP

Show Only

Looking for tag: pots